Switching Off The Machine - Kruger K100 Instrucciones Para El Uso

3 3 3 3 3
CONNECTION OF THE WATER SUPPLY
PIPE
Connect a clean water supply pipe (Fig. 4
– pos.3) to the water mains, checking to
ensure that the minimum pressure is of 1.5
bar and maximum is of 6 bar, with a
minimum flow rate of 7 l per min.
- Connect the water supply pipe (min. diam ½") to
the water mains (fig.3)
- Fit the click-on attachment (Fig. 4 - pos.1) onto
the fitting (2);
4 4 4 4 4
HIGH PRESSURE PIPE CONNECTION
- Insert the high pressure pipe (Fig. 5-pos.4) into
appliance attachment (5)
- Rotate the plastic ring nut, thoroughly tightening
it
- Turn on the water tap
Assembly of the detergent spraying device
(Fig. 6)
- Insert the sprayer pipe into the spray gun
- Rotate the pipe by 90°, and on extracting it, click it
in.
- Screw the head (6-7) onto the sprayer pipe (8)
until it is completely tightened (fig. 7)
5 5 5 5 5
ELECTRICAL CONNECTION OF THE
APPLIANCE
The mains voltage must match the operating voltage.
(See identification plate)
- Insert the plug into a power socket installed in
compliance with regulations.
Check the minimum section of the individual cables
using extensions.
Position the extensions so as to maintain the protection
class of the equipment.
Voltage V Cable
length
230 up to 2
230 20 to 5
6 6 6 6 6
APPLIANCE ACTIVATION
Operate the equipment in vertical position
only after connecting the water supply pipe
and turning on the tap (fig. 2 )
-
-
-
-
-
7 7 7 7 7
-
-
- Actuate spray gun until water drips from the nozzle
-
-
-
-
8 8 8 8 8
Variable nozzle head
The nozzle can be regulated in a continuous manner,
by rotating the regulation bushing, changing it from a
pinhole jet to a flat jet and viceversa (Fig.11).
Turbo nozzle (optional)
No adjustment is required for the turbo nozzle.
ADDITION OF DETERGENT
Cross-section
mmm2
1,5
-
2,5
-
-
-
11
Press button I (Fig.8-ON) on the main switch
positioned at the rear of the device
Position the spray gun on the object to
be cleaned - never on people !
Press the safety device (Fig. 9 - pos. 1) - the gun is
released
Direct the nozzle downwards (Fig.2)
Fully press down the trigger (Fig. 9 - pos.2)

SWITCHING OFF THE MACHINE

Press the button marked with an 0 0 0 0 0 on the switch
(Fig. 8 - OFF
OFF) OFF OFF OFF
Turn off water supply tap.
(machine is now de-pressurized).
Release trigger.
Press safety latch on spray gun. (Fig.10). The spray
gun is locked and cannot be actuated accidentally.
Unplug machine from socket outlet.
Disconnect water supply hose from machine and
water supply mains.
EQUIPMENT
The detergents must not be
allowed to dry on the object to
be cleaned.
Remove the spraying pipe by pushing it towards
the spraying gun, rotate it 90° and take it out.
(Fig.12).
Apply the detergent spray kit to the gun (Fig. 13).
Fill the container of the spray kit with suitable
detergent (see paragraph "General safety
recommendations" in this booklet).
After using the foam dispenser, hang it on the
hook on the rear of the machine (Fig.14).