Idiomas disponibles
Idiomas disponibles
Optional Connection
UPS Unit State when asserting EPO with AC line present:
LEDs
Output
OFF
OFF
To restart the UPS unit after asserting EPO with AC line present:
1. Verify that the EPO assertion has been removed or cleared.
2. Remove AC line power to the UPS unit.
3. Reapply AC line power. Now the UPS will start back up in Bypass mode and
the LCD will display "BYPASS MODE".
UPS Unit State when asserting EPO without AC line power:
LEDs
Output
OFF
OFF
To restart the UPS unit after asserting EPO without AC line power:
1. Verify that the EPO assertion has been removed or cleared.
2. Reapply AC line power to the UPS unit. Now the UPS will start back up in Bypass
mode and the LCD will display "BYPASS MODE".
External Battery Connection
3
Your UPS comes with a robust internal battery system; external batteries are needed
only to extend runtime. Adding external batteries will increase recharge time as well as
runtime. The illustration shows the location of your UPS's External Battery Connector,
where you will insert the battery pack cable. Complete installation instructions for your
battery pack appear in the battery pack Owner's Manual. Make sure that cables are
fully inserted into their connectors. Small sparks may result during battery connection;
this is normal. Do not connect or disconnect battery packs when the UPS is running
on battery power.
Accessory Slot
4
Remove the slot's cover to install an optional internal SNMP/Web accessory card
(Model: SNMPWEBCARD) to enable remote UPS monitoring and control via SNMP ,
Web or telnet. (Tripp Lite's RELAYIOCARD is also available.) Visit www.tripplite.com/
support for more information, including a list of available SNMP , network management
and connectivity products.
201102161 933070.indb 13
(continued)
SNMP
Fans
Serial
OFF
OFF
OFF
SNMP
Fans
Serial
OFF
OFF
OFF
LCD Screen
USB
OFF
"Emergency Stop"
LCD Screen
USB
OFF
"Emergency Stop"
13
3
4
NORMAL
3/29/2011 4:34:14 PM
Capítulos
