Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
(Fig 1)
Figure 1
Cover
Tube
Pump
Lower Basin
Adaptor
4
Main Body
Light Cord
Pump Power Cord
Figure 2
Attention:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
2. Familiarize yourself with the pump. The switch located at the front of the pump controls
the pump speed. The speed is indicated by a plus (+) and minus (-) sign. To increase
the speed, move the switch slowly left in the direction of the plus sign. You will hear a
click as the switch moves to each speed level. At its highest speed level, the switch
will cease to move any further. To decrease the pump speed, move the switch right
toward the minus sign. Similarly, at its lowest speed, the switch will cease to move
any further (Fig 2).
NOTE: It is recommended the pump be set at its highest speed during assembly and
later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting
the speed setting.
3. Insert the tube into the pump. (Fig. 1) Place the pump inside the middle of the lower
basin allowing the suction cups to sit flat on the bottom. Pump should not touch side
walls.
4. Lead the power cord up through the cord hole located on the back of the unit. (Fig. 3)
5. Insert waterproof light into the hole located on cover. (Fig. 4) Slight twisting may help
to push the bulb through the rubber seal more easily.
NOTE: Be gentle with the bulb since it is made of glass.
Figure 3
Power Cord
Minimum Water Level
Flow Control Valve
(+) faster water output
(-) slower water output
Figure 4
Rubber Seal
Cover
Waterproof Light
5
Tabla de contenido
