Regalo 1190 Manual Del Propietário página 9

STEP 7
Connect the assembled gate to the wall by inserting
the flat ends of the threaded rods into the semi-circle
slot at the bottom of each maxi mounting bracket.
Adjust the length of the threaded rods appropriately
to allow for installation. After proper insertion, the
threaded rods will lock in place.
NOTE: Install one side of the gate completely before attempting to install the
second side.
STEP 8
Adjust the threaded rods so that an equal amount
of spacing is distributed between the 4 corners.
Then, using a wrench, tighten the locking
nuts to lock the gate in place.
NOTE: The maximum length of the exposed threaded rods should not exceed
2.5 inches.
English 9