Tabla de contenido
LOADING THE
1
1. Open the back cover by sliding the release knob as shown above.
En
2. Insert a roll of film in the chamber. Do not force the film into position.
3. The film should lie flat.
4. Close the back cover. It will close with a "click".
5. The film will automatically advance until the film counter reads "1".
6. If a film is loaded incorrectly, the LCD panel will display an "E" warning signal. (Refer to page 23 for information
of buzzer operation.) Reload the film following the steps shown above.
NOTE
The camera automatically adjusts for ISO 50-3200 DX film.
When you use non-DX film, the camera will set the film speed at ISO 100.
Load the film in subdued lighting.
16
FILM/COLOCACIÓN DE LA PELÍCULA
3
2
4
5
6
Tabla de contenido
