Würth 0827 809 119 Traducción Del Manual De Instrucciones De Servicio Original página 12

Charging process (only for cordless LED lamps)
Before taking the hand lamp into service for the first time charge it for 6-8 hours.
■
Fully charge the hand lamp before it is stored for a longer period.
■
Connect mains adapter with the hand lamp.
■
Switch lamp off during charging.
■
Cordless LED front lamp DCM (Art. 0827 809 119)
3 The LED of the lamp switches to RED during charging.
3 If charging is completed, the LED of the lamp switches to GREEN.
Sensor function (only art. 0827 809 119)
To activate the non-contact sensor function, press
■
3 The lamp is switched on or off by a hand movement in front of the lamp head.
To deactivate the non-contact sensor function, press
■
Cordless LED hand lamp DCM (Art. 0827 940 119)
Charging process is completed as soon as all bar indicators of the charging state
■
display illuminate in WHITE.
If the lamp is switched off, press the on/off switch for 3 seconds to indicate the
■
battery residual capacity.
After 3 minutes the lamp switches to 50% lumen mode to save energy and prevent
■
overheating.
Cordless LED workplace lamp DCM (Art. 0827 981 119)
Charging is complete as soon as all LEDs (10 – 100) illuminate in RED and the LED
■
on the mains adapter switches from RED to GREEN.
Changing the colour temperature
With the lamp switched on press the on/off switch for 3 seconds.
■
Warm white 4,500 K:
Cold white 6,500 K:
12
Operation
BRIGHT surfaces
DARK surfaces
.
again.