TECNOMOTOR TM 540/2 Manual De Instrucciones página 37

Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar [email protected]
already in line with best practices in the field of eletrotecnia, the owner must
ensure that the deficiency is eliminated immediately, and if this situation gives
rise to a serious risk, should ensure that the installation or electrical equipment is
not operated with disabilities.
Essays
•
The owner must ensure that electrical installations and electrical
equipment are tested in good condition:
- Before first commissioning and after a change or repair before replacement
into service by an electrician or under the direction and supervision of an
electrician.
- In certain intervals. The limits should be determined so that the defects that
arise can be determined in time.
•
During the test must be complied with good practice in eletrotecnia.
•
If required by the professional association, you must have a book of
essays where certain records are entered.
3.1 Tensions network, high voltages
In network and electrical systems of cars occurring hazardous
voltages. Runs the risk of electric shock if contact with live parts
(for ex. Ignition coil) and / or be subject to discharge voltage due to
damaged insulation. This applies to the secondary side and the
primary of the ignition system, the bundle of electrical cables with
snap connections to the locations of light (Litronic) and also for
connection to the vehicle.
Security measures:
• Connect only taken with alveoli protected properly grounded.
• Use only the cable network connection supplied or tested.
• Use only extension cables with protected wells.
• Replace the cables whose insulation has been damaged.
• Tests and work adjustment should be made, preferably, with the ignition off
and the engine stopped.
TM 540/2
3. Safety instructions
35