Urmet miro 1750/15 Manual Del Usuario página 16

The window shutter controls may also be sent via lighting modules and vice versa. For further information on
the Radio Bus, refer to the "Yokis Radio Quick Installation Guide" or the www.yokis.com website.
HOW TO CREATE THE RADIO BUS BETWEEN DIFFERENT RECEIVERS
Quickly press "connect" on receiver 1. Its LED will starts blinking
"connect" on receiver 2
To confirm the connection, the LED of receiver 2 will blink once and the LED of receiver 1 will stop blinking.
The relays of the two receivers will switch once when the connection has been established.
Possible with all
Yokis receivers
1
INCREASING THE RANGE BY MEANS OF AN INTERMEDIATE RECEIVER
1. Connect the "Bus Radio" between the receivers as described above.
2. Connect the video door phone to the receiver to be controlled by quickly pressing the chosen video door
phone button 5 times (E5). While the LED of the video door phone is blinking, press in the "connect" hole
of the receiver 2.
3. Create an access point on the receiver closest to the video door phone, by pressing the video door
phone button (E7) 7 times (the same which was programmed in the previous step); the LED of the video
door phone will start blinking rapidly. Then press in the "connect" hole of the receiver 1 once: the LED
on the video door phone and the LED on the receiver will stop blinking.
CENTRALISATION VIA RADIO BUS
The following five steps must be taken to create a centralisation:
1. Create 'Bus radio' between receivers
Follow the procedure described above.
2. Connect the video door phone button to the nearest receiver
(It is recommended to connect the video door phone to the nearest receiver to avoid range problems).
1. Briefly press and hold the selected button of the video door phone 5 times.
2. While the video door phone LED is flashing, press briefly with the tip of a pencil into the "connect"
hole of the receiver.
3. The receiver will briefly switches the relay and the LED of the video door phone will switch off.
3. Set the button as centralised
1. Briefly press the video door phone button (Yokis Configuration Menu) 10 times. The video door
phone LED will blink rapidly.
2. While the LED is flashing, press the chosen button 6 times.
3. At the end of the pressures, the LED will blink 6 times to confirm the calibration.
4. Define whether centralisation applies to: 'lights' (default), 'shutters' or 'lights and shutters'.
By default the central button is set to operate the lighting modules (MTR2000ERP and MTV500ERP).
Skip this step.
Proceed as follows to control the MVR500ERP shutter modules centrally or operate lights and shutters
at the same time:
1. Briefly press any button on the video door phone (Yokis Configuration Menu) 10 times. The video
door phone LED will blink rapidly.
2. While the LED is flashing, press the chosen button 11 or 20 times.
3. At the end of the pressing sequence, the LED will flash 1 (o 10) times to confirm calibration.
16
.
2
. While the LED is blinking, press
3
1
Unlimited number
of receivers on
the radio bus
2
DS1750-014B
4