Kohler K-9530 Guia De Instalacion página 3

Before You Begin (cont.)
You can extend the distance between the water source and the
braided hose connection with 1/2" copper piping below the rim
of the bath/whirlpool, but it may not be safe or practical. A long
run of piping will mean a long run of room-temperature standing
water when the handshower is first activated for use.
This diverter can be used in either a deck-mount or wall-mount
installation. Refer to the "Diverter Configurations" section for any
special considerations.
Do not install spouts with flow restrictors or handheld shower
units on the large (5/8" OD) bath outlet.
The Kohler two-way diverter is designed for use with Kohler
non-diverting bath spouts.
Remove all internal components of the diverter valve before
soldering. Kohler Co. recommends soldering supply and optional
outlet connections to avoid potential leakage.
Kohler Co. reserves the right to make revisions in the design of
products without notice, as specified in the Price Book.
Kohler Co. 3 113228-2-CC