Ingersoll Rand SS3F2-GM Manual Del Propietario Con La Lista De Piezas página 8

EN
Follow the procedures outlined below to correctly set and
measure belt tension.
1. Lay a straight edge across the top outer surface of the
belt drive from pulley to sheave.
2. At the center of the span, perpendicular to the belt,
apply pressure to the outer surface of the belt with a
tension gauge. Force the belt to the deflection indicated
in the table at right. Compare the reading on the tension
gauge to the table below.
Deflection in Min . Tension
Inches (Lbs .)
0.17 3.0
Ensure the pulley and sheave are properly aligned and
the motor anchor screws are adequately retightened
prior to restarting the compressor .
8
RELEASED 26/Jan/2020 20:37:54 GMT
Max . Tension
(Lbs .)
6.0
NOTICE
CAUTION
Improper pulley/sheave alignment and belt tension
can result in motor overload, excessive vibration, and
premature belt and/or bearing failure .
To prevent these problems from occurring, ensure
the pulley and sheave are aligned and belt tension is
satisfactory after installing new belts or tensioning
existing belts .
TANK INSPECTION
The life of an air receiver tank is dependent upon several
factors including, but not limited to, operating conditions,
ambient environments, and the level of maintenance. The
exact effect of these factors on tank life is difficult to predict;
therefore,
Ingersoll-Rand recommends that you schedule a certified
tank inspection within the first five years of compressor
service. To arrange a tank inspection, contact the nearest 1-R
Air Center or distributor, or call 1-800-AIR SERV.
If the tank has not been inspected within the first 1 O years
of compressor service, the receiver must be taken out of
service until it has passed inspection. Tanks that fail to meet
requirements must be replaced.
WARNING
Failure to replace a rusted air receiver tank could result
in air receiver tank rupture or explosion, which could
cause substantial property damage, severe personal
injury, or death . Never modify or repair tank . Obtain
replacement from service center .
22204861 Rev. C