Vacuum Bag Working Process - EAS ELECTRIC EMS419VSX Manual De Instrucciones

12. When the vacuuming process is
complete, a done LED will light on
the display.The vacuum bag can then
be removed from the compartment.
(Figure 3).

3.5 Vacuum Bag Working Process

13. After pressing the button, the
mechanism moves up and starts to
compress the bag. The ready LED will
light.
14. After the bag is compressed, the
vacuum process is commenced by the
vacuum pump. The vacuum LED will
light.
15. When the system reaches its intended
vacuum limit, resistance starts to melt
the mouth of the bag. The seal LED will
light.
16. After the sealing process is complete,
the mechanism moves down and the
seal done LED will light. As the motor
returns to the irst position, the done LED
goes out and the process is complete.
• All lights are turned off for 1 minute after
the process is completed, during this time
the system cannot be activated.
• When the start and ready lights switch
on, the system is ready for use again.
Cancelling Process:
• If you require the vacuum process to be
cancelled (except the sealing stage),
press the start button for two seconds.
• The Start LED goes off when the process
is cancelled.
Important Note:
Working noise may be heard from the
motor and pump during the operation
of the system.
If engine noise persists for a long time,
call for technical service.
When vacuuming and locking
processes are not complete, this may
have been caused by any misuse.
Therefore, the recommendations section
must be read. If the same error is
encountered in successive operations, call
technical service.
If you want to completely turn off the
vacuum system, you can press the on-
off button for 3 seconds. For same way,
you can activate vacuum system again
whenever you want. For same way,
you can activate vacuum system again
whenever you want.
EN - 95
V.1