Using the installation instructions
Please read the installation instructions and safety information before SERVO-DRIVE installation.
We recommend that you use the orientation diagram for easier identification of the parts being de-
scribed.
These installation instructions apply to the SERVO-DRIVE electrical motion support system for:
- the lift systems AVENTOS HF, AVENTOS HS, AVENTOS HL and AVENTOS HK
- the TANDEMBOX pull-out system and the TANDEM runner system
However, only AVENTOS HF is used as an example in the illustrations.
Please see the special AVENTOS installation instructions for the assembly steps for the mechanical
AVENTOS HF, HS, HL and HK lift systems without SERVO-DRIVE.
Intended use
SERVO-DRIVE supports the opening and closing of lift systems and/or the opening of pull-out ele-
ments, and may only be used under the following conditions:
•
In dry, enclosed rooms.
•
In combination with AVENTOS lift systems and/or pull-out systems from Julius Blum GmbH within
permitted technical specifications.
•
In combination with a Blum transformer.
Safety
SERVO-DRIVE complies with current safety standards.
Nevertheless, there are certain risk factors if these installation instructions are not followed. Please
be aware that Julius Blum GmbH is not responsible for incidental or consequential damages that may
arise due to non-compliance with these installation instructions.
•
All national standards must be followed for SERVO-DRIVE assembly. This includes, in particular,
those related to the mechanical safety of moving parts and electrical cabling.
•
Only qualified technicians may install/replace Blum components, modify the position of the Blum
transformer or modify any cabling.
•
The device may only be connected to a power supply that corresponds to the type and frequency
listed on the serial tag (see Blum transformer).
•
The outlet must be freely accessible.
•
Only 1 Blum transformer can be connected to each distribution cable.
60