Tabla de contenido
Idiomas disponibles
Idiomas disponibles
a)
Place the filter support (P/N N750038) on the cartridge so the eight indented notches nestle on the inner raised circle
and the part number "N750038" is not backwards (see Figure 3).
Place each filter into the filter cover (P/N N750027), paying attention to the instructions on the filter "this side towards
b)
face" or "this side away from face" (see Figure 1). Snap the filter assembly onto the cartridge filter "this side towards
face" or "this side away from face. Snap the filter assembly onto the cartridge (see Figure 4)
Figure 3
3. If you are using flexible filters with a gas or vapor cartridge, you will need two N750035 adapters in addition to the filters.
a)
Snap the N750035 onto the cartridge.
b)
Being careful not to cross thread, attach the filter to the adapter. Proceed to Step 5.
4. If you are using the Backpack Adapter (P/N BP1002) with any combination of filters or cartridges, attach them to the male
threaded end of the adapter. Check that the cartridges or filters are effectively sealed against the gasket on the back plate
connector.
Figure 4
9
Tabla de contenido
