Tripp-Lite PDU3EVN3L2130 El Manual Del Propietario página 15

Features
Network Interface
C
C1 C2
D
Ethernet Port: Use this RJ45 jack to connect the PDU to the network with a standard
C
Ethernet patch cable. The behavior of the Activity LED
table below. This port is not compatible with PoE (Power Over Ethernet) applications.
LED Function
Activity
Link
SNMP Reset Button: The reset button is recessed. Use a paper clip or other suitable object D
to press the reset button for 3 seconds to reboot the PDU's network interface. Rebooting
the network interface will not erase network settings or interrupt AC power. Press and hold
the reset button for 20 seconds to restore the PDU's network interface to its factory default
settings. Restoring to the factory default will erase all previously saved data—including
network settings—without interrupting AC power.
21-03-434-93349E.indb 15 21-03-434-93349E.indb 15
C14 Plug-Lock Inserts (Optional): Use the included C14 plug-lock
inserts to secure plugs to C13 receptacles. Attach the sleeve to the plug
making sure the pull tabs remain outside the plug and that the fit is
secure. To unplug equipment properly, use the pull tabs to remove the
plug and insert from the receptacle.
C20 Plug-Lock Inserts (Optional): Use the included C20 plug-lock
inserts to secure plugs to C19 receptacles. Attach the sleeve to the plug
making sure the pull tabs remain outside the plug and that the fit is
secure. To unplug equipment properly, use the pull tabs to remove the
plug and insert from the receptacle.
Ground Screw: Use this to connect any equipment that requires a
chassis ground.
USB Ports: The two USB-A ports
A
A
to one of four different Tripp Lite EnviroSense2 (E2)
environmental sensors* for remote temperature or
A3
temperature/humidity monitoring (up to three E2 sensors
can be daisy-chained). The USB-B port
initial network interface configuration and direct console
A2
access from a laptop**.
A1
*USB-A ports are designed for use with E2 modules only. Do not
connect other USB devices to these ports.
B
**Only 2 of 3 USB ports can be used simultaneously. For example:
2 USB-A (
and
port
RJ45 Configuration Port: This port can also be used to
B
configure the network interface and command line access
from a laptop.
LED Color
Green
Yellow
and ), or 1 USB-B and the lower USB-A port (
A1 A2
); the upper USB-A port A1 A2
.
A3
and Link LED
C1
Off
No Activity
No Link Link (Any Speed)
15
and connect
A1 A2
is used for
A3
cannot connect with the USB-B
is shown in the
C2
On Flashing
— Activity
—
4/5/2021 4:11:51 PM 4/5/2021 4:11:51 PM
A3