Application; Connecting To Cs-300 Shank; Safety Precautions - Nippon Gases CS-300 OXIGAS-P/GN Intrucciones De Manejo Y Seguridad

1. APPLICATION

EN
The OXIGAS-A CS-300 NIPPON GASES attachment for oxy-cutting is designed to be connected to
PT
NIPPON GASES CS-300 shank (Cod. 2302005) for use in oxy-cutting applications with Oxygen &
Propane or Natural Gas. It works with two-parts S-21P nozzles (see table 8 with material thickness
& pressures).
EN

2. CONNECTING TO CS-300 SHANK

2.1. Remove screw & tap from CS-300 shank.
2.2. Insert the mixer of attachment on the frontal tube of the shank, set by pushing from head
of attachment if necessary: in such a way that the seat of oxygen valve for cutting will be
set in valve body of shank.
2.3. Screw & tighten with a wrench, gas tightness is metal/metal.
2.4. Screw & tighten nut of attachment on the shank till closing (tightness is made with an O-
ring & by metal/metal contact on the oxygen circuit).

3. SAFETY PRECAUTIONS

Before connecting the torch & during the whole operation, take care to follow these
instructions. In case of doubt, get in touch with NIPPON GASES.
3.1. Only use genuine & appropriate accessories from NIPPON GASES (cutting nozzles &
spare parts).
3.2. NEVER USE OIL OR GREASE with any component of the equipment.
OXYGEN WITH OIL AND GREASE: DANGER OF EXPLOSION.
3.3. Do not set pressures that are really different from those recommended.
WRONG PRESSURES = DIFFICULT FLAME CONTROL & RISK OF GAS BACKFLOWING.
3.4. SET ASIDE:
-
-
-
ESCAPES & OBSTRUCTIONS = DANGER OF GAS ACCUMULATION &/OR GAS BACKFLOWING.
20
Torches with gas escapes and/or too many crackers.
Damaged nozzles or tips.
Old hoses.
ATTACHMENT FOR OXY-CUTTING CS-300, OXYGAS-P/GN