Installation - Isotherm Cruise Silver CR165 Instrucciones Para La Instalación Y El Uso

User Manual

4.1 Installation

Isotherm refrigerators have been designed and constructed exclusively for recessed
installation and installation that is in compliance with standard dimensions. The
refrigerator must always be in a horizontal position, with the compressor's rubber
feet at the bottom. The compressor is capable of functioning at angles of up to 30°.
The compressor can become damaged with any higher inclinations.
Also remote operation compressors must be installed with its rubber feet
downward.
It is important not to pierce the sides of the refrigerator where the yellow warning
label is present (Fig.1 and Fig.2). This is because the evaporator is foamed into the
sides of the refrigerator and applying any brackets or supports is likely to pierce
the same, causing the refrigerant gas to leak and damage the product beyond
repair.
Fix the product to its base using the appropriate fastening bracket supplied (Fig. 4) at
the top using the appropriate fastening brackets supplied (Fig. 3).
Important: never remove product support feet.
When it is not possible to use the mounting brackets, secure the refrigerator in such
a way so that it will not tip/slide forward when the drawer is opened or in the case
of sudden vehicle movement. The unit should be anchored by at least 2 fastening
points, in accordance with the provisions of the EN 60335-2-24 standard.
49