Tripp-Lite PDUMNH16HVAT El Manual Del Propietario página 4

2. Installation
Align the rear segments of the bracket set
C
with the cage nuts.
Insert and tighten four Phillips pan-head
D
screws (provided with your rack enclosure).
Attach Front Rail Segments to the Automatic Transfer Switch
Align the front rail segments of the bracket
E
set with the corresponding holes located
on the sides of the Automatic Transfer
Switch (ATS).
Attach both front segments to each side of
F
the ATS using six Phillips flat-head screws
(included).
Install the Automatic Transfer Switch in the Rack Enclosure
Note: Two people should perform this procedure.
Position the ATS in front of the mounted
G
rear rail bracket segments.
15-09-215-93338F.indb 4
C
D
E
F
G
4
9/30/2015 4:56:26 PM