Installation; Mounting The Ats; Rack Mounting - Tripp-Lite PDUMNH16HVAT El Manual Del Propietario

2. Installation

2.1 Mounting the ATS

The ATS supports 1U rack configurations.
Notes:
• The instructions described in this guide are for common rack and rack enclosure types and may not be
appropriate for all applications. The user must determine the fitness of hardware and procedures before
mounting. If hardware and procedures are not suitable for your application, contact the manufacturer of your
rack or rack enclosure for a solution.
• The user must determine the fitness of hardware and procedures before mounting. The PDU and included
hardware are designed for common rack and rack enclosure types and may not be appropriate for all
applications. Exact mounting configurations may vary.
• Rackmount equipment may be extremely heavy—be careful when moving or lifting equipment. Use one or more
assistants if necessary.
2.1.1 1U Rack Mounting
Attach the PDU to the rack by inserting four
user-supplied screws
mounting brackets
holes of the rack rail as shown.
2.1.2 Rear Rack Rail Kit Installation
For additional stability, a front and rear rail kit can be used for rack mount installations. This kit is
included for models PDUMNH30HVAT and PDUNH32HVAT, but can also be purchased separately
for models where it is not included.
Disassemble the Bracket Sets
Note: This rail kit is only compatible with a 4-post rack or rack enclosure.
Disassemble each bracket set by sliding
A
them apart.
Attach Rear Rail Segments to the Rack
Insert two cage nuts (provided with your
B
rack enclosure) on each of the rear vertical
mounting rails of the rack enclosure at
your desired location.
15-09-215-93338F.indb 3
through the PDU
A
and into the mounting
B
A
B
A
B
3
A
9/30/2015 4:56:24 PM