Idiomas disponibles
Idiomas disponibles
Operation
Startup Self-Test
When you turn the UPS ON, it will enter Diagnostic Mode and perform a brief self-test lasting about 15 seconds. The results of the self-test
are shown on the LCD screen in the sequence below.
*Note: If the UPS is cold started, its BATTERY LED will be lit.
Failed Self-Test
If a problem is detected during the self-test, the LCD will display a error message. If your UPS displays any of the following messages in
its LCD, call Tripp Lite Technical Support at (773) 869-1234 for service.
STARTED WITH
AC INPUT
DIAGNOSTIC MODE
FREQ OUT = XXHz
M
DIAGNOSTIC MODE
INPUT AC OK
M
DIAGNOSTIC MODE
INPUT AC OK
M
DIAGNOSTIC MODE
BATTERY OK
M
DIAGNOSTIC MODE
CHARGER OK
M
DIAGNOSTIC MODE
AC/DC OK
M
DIAGNOSTIC MODE
TESTING INVERTER
M
ONLINE MODE
LOAD = XXX% X.XXKW
BAD BATTERY!
CALL FOR SERVICE
CHARGER FAILURE!
CALL FOR SERVICE
AC/DC FAILURE!
CALL FOR SERVICE
INVERTER FAILURE!
CALL FOR SERVICE
OUTPUT FAILURE!
CALL FOR SERVICE
FAN FAILURE!
CALL FOR SERVICE
12
COLD
START*
DIAGNOSTIC MODE
FREQ OUT = XXHz
M
DIAGNOSTIC MODE
INPUT AC BAD
M
DIAGNOSTIC MODE
INPUT AC BAD
M
DIAGNOSTIC MODE
BATTERY OK
M
DIAGNOSTIC MODE
AC/DC OK
M
DIAGNOSTIC MODE
TESTING INVERTER
M
ON BATTERY MODE
LOAD = XXX% X.XXKW
Capítulos
