Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. To maintain the easy adjustability of the
resistance system, the screw threads on the lower
end of the brake rod should be lubricated. First,
turn the resistance knob clockwise until it stops.
Next, look under the right or left side of the frame
and locate the brake rod (C). Apply a small amount
of synthetic grease (white lithium grease) to the
thread on the brake rod. Then, turn the resistance
knob counter-clockwise until it stops.
3. Some parts of the LIVESTRONG E-Series may
become loose as a result of repeated use. Check
pedals, toe clips, and pedal straps, and make sure
that they are properly tightened. Next, check all
exposed screws, bolts, and nuts, and make sure
that they are properly tightened. Finally, check the
saddle to make sure that it is not lose damaged.
4. The brake pad will become worn as a result of
repeated use. The LIVESTRONG E-Series should
not be used if the emergency braking system is not
working properly (see page 13)! Should you feel that
the resistance system's functions are deficient, it is
essential to fine-tune the resistance system before
the bike is used again! Please check the setting of
the brake system as follows: First turn the resi-
stance regulator on the brake system as far as
it will go to the left (minimum braking effect). If the
setting is correct, the brake pads should be flush
with the flywheel and barely touching so that it's
possible to cycle with a hardly noticeable amount
of resistance. The brake pad can be adjusted using
a 10 mm wrench. Next, check the brake pad for
signs of wear. If the brake pad does show signs of
excessive wear, thoroughly soak the brake pad
with lubricant spray using the 2 lubrication holes
(B),
and
then
Version 1.1 SBLS Copyright by Indoorcycling Group GmbH 2010
wipe
the
excess
PREVENTATIVE MAINTENANCE
2
5
6
off.
|
www.indoorcycling.com
C
C
ENG 27
Tabla de contenido
