Cleaning The Interior; Control Panel; Temperature Indicator - De Dietrich PSS300 Manual De Instrucciones

Frigorifico-congelador
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

USE

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
thoroughly.

Control Panel

A
On/OFF light
B
Fridge button ON/OFF
C
Temperature setting button (warmest)
D

Temperature indicator

E
Temperature setting button (coldest)
F
Coolmatic light
G
Coolmatic button
A. Light ON/OFF
B. Button ON/OFF
ON:
Press the button (B). The pilot light (A)
switches on.
OFF: Keep press the button (B) until the pilot light
(A) and the temperautre indicator switched off.
C - E. Temperature setting buttons
The temperature can be adjusted between +2°C and
+8°C.
By pressing the button (C or E), the current
temperature setting flashes on the indicator. It is
possible to modify the setting temperature only with
flashed indicator. To set a warmer temperature,
press button (C). To set a colder temperature, press
button (E). The indicator display the newly selected
temperature for a few seconds and then shows
again the inside compartment temperature.
The newly selected-temperature must be reached
after 24 hours.
A B
C
D
Do not use detergents or abrasive
powders, as these will damage the finish.
E F G
Attention!
During the stability period by the first starting the
temperature displayed can not correspond to the
setting temperature. During this time it is possible
that the temperature displayed is lower than the
setting temperature.
D. Temperature indicator
During normal functioning the indicator shows the
temperature inside the fridge.
Attention!
Difference between the temperature displayed and
temperature setting is normal. Especially when:
-
a new setting has recently been selected
-
the door has been left open for a long time
-
warm food has been placed in the compartment
F. Coolmatic pilot light
G. Coolmatic button
The maximum performance is obtained by setting
the Coolmatic function. It's recommended when
loading large quantities of food.
Press the Coolmatic button (G).The relevant pilot
light (F) switches on.
The internal temperature goes down to +2°C.
After about 6 hours the Coolmatic function switches
off automatically.
33
Tabla de contenido
loading

Tabla de contenido