Polar DB331 Manual De Instrucciones página 8

UK
• To carry out easy cleaning and maintenance,
the upper parts of the side protectors can be
removed. When necessary, lift the upper part
to remove. Once done with cleaning, re-locate
the part in place.
Disassembling the tap assembly
1. Disassemble the tap and remove the pin (F)
from its seat to release all the other parts.
2. Wash the parts thoroughly and let them dry.
Removing the bowl
1. Remove the bowl lid.
2. Raise the front part of the bowl to release it.
8
DB331_DB332_DB843_ML_A5_v2_20210701.indb 8 DB331_DB332_DB843_ML_A5_v2_20210701.indb 8
3. Remove the bowl from its seat by pushing and
tapping lightly on the rear part.
4. Take out the auger. Then remove the seals (A
and B).
5. Clean and sanitize all the dismantled parts
(excluding the lid), following below instructions:
• Wipe the parts with a sponge soaked
with a sanitizer solution.
• Rinse the parts thoroughly with clean
water.
• Soak the parts into the sanitizer solution
for about 30 minutes.
• Wash the parts again with clean water.
• Let dry thoroughly.
2021/7/2 14:39 2021/7/2 14:39