Error Codes - Klarstein 10030152 Manual Del Usuario

• Do not move or move the appliance while it is running. Do not exceed the weighing capacity of apparatus. Do
not force the working capacity of the apparatus. Respect the maximum and minimum level.
• After use, disconnect, not rely on the detection container.
• Unplug the device from the network when not in use before any cleaning operation, adjustment, or laod chan-
ging accessories. This appliance is intended only for domestic use, not commercial or industrial.
• This appliance is designed so that it adult use.
• Do not allow the use people unfamiliar with this type product, disabled, or children.
• Keep this product out of reach children and / or disabled.
• Do not store the device if it is still hot.
• Maintain in good condition. Ensure that no moving parts they misalignment or binding, not breakage of parts
and other conditions they can affect the proper functioning apparatus.
• Check that the jar is properly placed before starting the apparatus.
• Check periodically the perfect using state of the lid seal.
• Check that the cover is perfectly closed before starting the apparatus.
• Do not remove the lid while the liquid in the container is boiling.
• Always use the appliance under supervision.
• Pay special attention during assembly operations, removal of accessories, since the blades are sharp, proceed
with caution and avoid direct contact with the edge of the same.
• Any improper use, or accordance with the instructions of use, may involve danger, canceling warranty and
liability manufacturer.
Protector device error information displayed: The screen will appear E1 if the jar is not correctly inserted in the
E1 base. The unit will stop working automatically. Please power off the plug and pull out the jar, then re-insert in
the base. Please make sure the jar cannot be carried up if do not press the LOCK button.
Protector device error information displayed: The screen will appear E2 if the NTC of temperature sensor is
E2
damaged. The machine will stop working, and please Check and arrange for a qualified technician to repair.
Motor protective device: The screen will appear E3 if the food is too much and exceed the torque range of the
motor can bear. The machine will stop working automatically. Please power off the plug and pull out the jar, then
E3
reduce the food portion or add some liquid, wait for 5 minutes, and insert the jar into the base and re-start. If E3
appear again, please contact customer service.
Motor protective device: The screen will appear E4 if the food is overloaded and the machine is working too long, which will cause the temperature of the motor being too high. The machine will stop working automatically. Ple-
E4
ase power off the plug and pull out the jar, then reduce the food portion or add some liquid, wait for 30 minutes,
and insert the jar into the base and re-start. If E4 appear again, please contact customer service.
Protector device error information: If the screen appear E7, it means the jar bottom is overheating, which will
cause the machine will stop automatically. Please pull out the plug and wait for 15 minutes, and Inspect if it is
caused by below problem: 1. There is no food or waterwhen the machine is heating, which causes the machine
in boil-dry situation. Please put some food or water when heating. 2. Do not adjust the rotating speed when the
machine is heating the food which is heavy starchiness or heavy carbohydrate such as potatoes, butter/cream,
E7
sugar or the soup with flour. This will cause the food uneven heating and make the jar bottom overheating.
Please adjust the rotating speed upto speed 2 or above. 3. The machine is heating for too long makes the water
content of food or water boiled away. Please check when the machine is heating, if this situation happens, please
add some water, especially the steam function, if just add 500ml water at the beginning of working, should add
250ml water each 15 minutes.

Error Codes

18