Getting Started - Remington Endurance MB4200 Manual Del Usuario

ENGLISH

GETTING STARTED

CHARGING YOUR APPLIANCE
• Only charge from 5V DC 0.5-1.0A (minimum) adapters.
• Note: It is recommended to fully charge your appliance before using for the first time.
Please refer to the charge times shown in this book.
• Ensure the product is switched off.
• Connect the product to the USB cable and then the USB end of the cable to a powered
USB port.
CHARGE LEVEL INDICATORS
Charge Level
Charging
Low battery
Fully charged
• When in use;
• 3 Blue LEDs indicate 70% - 100% charge remaining.
• 2 Blue LEDs indicate 40% - 70% charge remaining.
• 1 Blue LED indicates 10% - 40% charge remaining.
• 1 Red LED indicates 5% - 10% charge remaining. 1 Red flashing LED indicates less than
5% charge remaining as noted in the above section on low battery charge level
indicator.
• Run time from fully charged is up to 90 minutes when not operated in turbo mode.
• Charge time from empty is 4 hours.
QUICK CHARGE FUNCTION
• The trimmer has a 5 minute quick charge feature that will provide enough charge for 1
grooming session.
ENDURANCE TECHNOLOGY AND TRAVEL LOCK
• The product will only charge when the travel lock, found on the back of the product is
disabled.
• To enable the endurance technology to operate please ensure you activate the travel
lock in between uses of the groomer by sliding down the travel lock.
INSTRUCTIONS FOR USE
• Switch the product on by pressing the On/Off switch.
• This model has a turbo mode that can be activated by pressing down the On/Off switch
for 2 seconds.
4
Indicator
LED flashes
LED flashes red
LEDs show solid