Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE PROTECTION GUARD
Before any work on the machine itself, pull
the mains plug.
For work with grinding or cutting discs, the
protection guard must be mounted.
The coded projection (13) on the protection
guard (10/12) ensures that only a guard that fits
the machine type can be mounted.
Loosen the clamp adjustment screw (7), if necessary.
Place the protection guard (10/12) with coded
projection (13) into the coded groove on the
spindle collar of the machine head and rotate to
the required position (working position).
The closed side of the protection guard
(10/12) must always point to the operator.
Tighten clamp adjustment screw (7). (See Fig 3)
OPERATION
STARTING OPERATION
To start the power tool, push the on/off switch (2)
forward.
To lock the on/off switch (2), press the on/off switch
(2) down at the front until it engages.
To switch off the power tool, release the on/off switch
(2) or, if it is locked, briefly push down the back of the
on/off switch (2) and then release it. (See 5)
OPERATING INSTRUCTIONS
●
Clamp the workpiece if it does not remain
stationary due to its own weight.
Do not strain the machine so heavily that it
comes to a standstill.
●
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Pull the plug from the socket-outlet when
●
not using the machine. With the plug
inserted and mains voltage existing, the
power tool still has low power consumption
even when it switched off. (See Fig 4)
1. Hand grip areas
Always hold your angle grinder firmly with both
hands when operating (See 6).
39
Tabla de contenido
