Battery Removal - Remington Ladyshaver WDF4840 Manual Del Usuario

ENGLISH
• Do not clean the shaving foil with a brush.
• At regular intervals, put a drop of sewing machine oil onto the foils and
cutter head. Remove excess oil.
, REPLACING THE FOILS AND CUTTERS
• To ensure the continued highest quality performance from your shaver, we
recommend that the foil and cutter are replaced every 6 months. These can
be obtained from our nearest Remington® Service Centre
, SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING.
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel
the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Ensure the shaver is switched off.
• Gently push the small plastic area at either end of the foil. The foil should
then easily detach from the head assembly.
• To reassemble, slide the foil into foil bracket and click into position.
• Close the head assembly.
, CAUTION
• Only hold the plastic to prevent damage to the foil.
• Do not press on the foil when replacing.
, REPLACING THE CUTTERS
• Ensure the shaver is switched off and open the head assembly (as above).
• Grasp the ends of the cutter between your thumb and forefinger and pull
upwards.
• To reassemble the cutter, place onto the oscillator tip. Gently push the centre
of the cutter, until it clicks into place.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Ensure battery is discharged.
• Remove the shaver head from the unit.
• Using a small screwdriver, remove the screw from the bottom of the shaver.
• Pry the front panel from the front housing and remove the switch button.
6