EQUATION EQH-70 Instrucciones Para Instalación, Uso Y Mantenimiento página 19

LEVELLING THE EQH-70 FIREPLACE
If, in order to transport the housing to its installation location, it were necessary to dismantle the
fireplace as indicated in the previous paragraphs; it is possible that, once assembled again, the external
edges of the fireplace will not be perfectly aligned with the housing. In order to correct this situation,
the base section that supports the insert features four levelling screws.
These four screws are located in the four bottom corners of the device. By tightening one or the other,
you will make the unit tilt to one side or the other to align the insert with the housing.
The levelling screws are located in the ceiling inside the log chamber.
4. INSTALLATION
The base where the EQH-70 HOUSING is to be placed must be flat and free from uneven areas that
may affect its perfect installation. The base must be built using resistant materials capable of
supporting the weight of the unit.
Once the housing has been positioned in its final location, level it if necessary. This can be done by
following the instructions indicated below:
8. Once body section has been removed from the
EQH-70 Fireplace, it can be removed.
To assemble the body section again, follow the same
steps in the opposite order.
19