Balancing The Main Rotor Blades And Tail Blades; Adjusting Blade Tracking; Power Checking - Carson Bluster 500 Instrucciones De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

j. Balancing the Main Rotor Blades and Tail
Blades
k. Adjusting Blade Tracking
Mark for adjustment
Using the small coloured pieces of tape provided in the kit, affix
the tape to the ends of the rotor blades as shown in the picture.
Hover the helicopter and observe the blade tips, they should
appear to be on one plane or you should see just one blade
when viewed from the end of the blades. If one blade appears
higher than the other adjust the low blade by turning the ball
link one turn at a time either clockwise or counter clockwise
l. Power Checking
Please check the following items when power and speed
appear low.
1. Whether the battery has enough power to properly power
the motor.
2. Pitch is too high or too low (over pitch will affect power and
flight times).
CARSON 3D Helicopter Bluster 500 · 50 050 7036
Mark for adjustment
Check and correct the balance of the main rotor blades before
your first flight. Place a 3M screw through the two main blades
as shown in the diagram. Tighten the blades and ensure that
they are straight as shown in the diagram. Add tape to the
higher blade until the two blades become level. Repeat the
same process for the tail blades.
Mark for adjustment
until both blades are tracking on the same plane, see diagram.
This adjustment is carried out on the ball joint connection that
comes from the rotor blade holder.
Never keep your eyes on the level of revolving blades to
avoid any hurt from flying off blades accidentally.
3. Blade tracking is correct, if the blades are out of track there
will be less power and more vibration.
4. There is a shake when spooling up the helicopter, either
fighten or loosen the blade grips so that both blades are
equally tight.
GB
17
Tabla de contenido
loading

Tabla de contenido