Stihl FS 94 R Manual De Instrucciones página 30

English
Starting the engine
5
Press the fuel pump bulb (5) at least
N
5 times - even when bulb is filled
with fuel
Cold engine (cold start)
1.
6
2.
Turn the knob for warm start (6) and N
then press to g
Also use this setting if the engine has
been running but is still cold.
Turn thumb wheel as far as possible
–
in the direction+
Hot engine (hot start)
The knob for warm start (6) remains
N
in position F
28
Actuating
Place the unit on the ground in a
N
secure position It should rest on the
support on the engine and the
cutting attachment guard.
(if present): Remove the transport
N
guard on the cutting attachment
The cutting attachment must not touch
the ground or any other objects – risk of
accident!
safe standing - possibilities:
N
standing, bent or kneeling
Press the machine firmly against
N
the ground with the left hand – do
not touch the throttle trigger, throttle
trigger lockout or stop switch while
doing so
NOTICE
Do not stand or kneel on the shaft!
Grab the starter grip with your right
N
hand
Pull the starter grip slowly until you
N
feel it engage and then give it a
brisk, strong pull
NOTICE
Do not pull out the starter rope
completely – risk of breakage!
Do not let the starter grip snap back
N
– guide it slowly back into the
housing so that the starter rope can
rewind properly
actuate until the engine starts!
N
Once the engine is running
At temperatures below +10 °C (+50 °F)
Allow the machine to warm up in
position g for at least 10 seconds.
At temperatures over +10 °C (+50 °F)
Allow the machine to warm up in
position g for approx. 5 seconds.
FS 94 R