Balancing the Machine
Adjust the carrying ring.
N
Tighten the screw moderately.
N
Let go of the brushcutter and check
N
to see how it is balance – the cutting
attachment should just touch the
ground in the normal working
position.
Move the carrying ring as required.
N
When the correct balanced position has
been reached:
Tighten down the screw on the
N
carrying ring firmly.
Disconnecting Machine from Harness
1
2
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
FS 94 R
Starting / Stopping the
Engine
Controls, parts
4
2
1
Throttle lever lock
2
Throttle trigger
3
Stop switch – with settings for Run
and Stop. To switch off the ignition
system, the stop switch (...) must
be pressed – see "Function of the
stop switch and the ignition"
4
Thumb wheel – to limit the throttle
1
path – see "Function of thumb
wheel"
Function of the stop switch and the
ignition
If the stop switch is actuated, the ignition
is switched off and the engine is
switched off. When released, the stop
switch automatically returns to the Run
position: After the engine has stopped,
the ignition is automatically switched on
again in the Run position – the engine is
ready for starting and can be started.
Function of thumb wheel
3
The thumb wheel (4) is used to set the
throttle path infinitely between idling and
full throttle and therefore also the engine
1
speed range:
Turn thumb wheel (4) in – direction:
–
the throttle path is shorter and the
set maximum engine speed is lower
Turn thumb wheel (4) in + direction:
–
the throttle path is longer and the set
maximum engine speed is higher
Press the throttle trigger forcefully to
–
apply full throttle even if limitation
set– the set limitation is maintained–
when the throttle trigger is released,
it is back in the preset range.
English
4
27