Utilitech PPSP33 Manual Del Usuario página 6

3. Connect a flexible connector (sold separately) to the
check valve.
4. Place the pump (A) in the sump pit. Make sure that
nothing interferes with the float switch operation.
NOTICE: Remove all small stones, gravel, mud, or
other debris from the sump pit before installing the
pump (A). The minimum diameter of the sump pit is 14
in. The minimum depth of the pit is 16 in. Construct the
sump pit with tile, concrete, steel, or plastic. Check your
local plumbing codes for approved materials and proper
installation.
5. Connect the discharge pipe to the other end of the
flexible connector and tighten the clamp with a
screwdriver.
NOTICE: A rigid discharge pipe is recommended to
prevent the pump (A) from moving. If a flexible
discharge hose is used, the pump (A) must be secured
in a manner that prevents it from moving. If it is allowed
to move, the float switch could be restricted by the
sump wall, preventing the pump (A) from turning on or
off.
NOTICE: After the installation of the necessary
plumbing, check valve and flexible connector, follow the
glue manufacturer's instructions for safety precautions
and curing time.
6