Memory Full; Memory Card Protected - Silvercrest SMS 5.0 A1 Manual Del Usuario E Información De Servicio

Memory full

The inserted memory card is full if no reaction occurs after pressing the OK/Capture button [3] in
record mode.
To be able to record more images, you should then transfer the previously recorded images to a
computer and format the memory card. To this end, please read the section "USB mode" on page
103 and "Formatting the memory card" on page 104.
Alternatively, you can also insert a new memory card. In this case, please read the section
"Inserting memory card" on page 93.

Memory card protected

If, after pressing the OK/Capture button [3], the following message is displayed on the screen [8]
for a short time in record mode, the write protection is activated for the memory card in use.
The memory card is equipped with a write-protect switch. If the write protection is activated (see
right illustration below), you cannot record any images.
Write protection deactivated
Deactivate the write protection (see left illustration above) and insert the memory card again into
the deactivated multi scanner. To do so, slide the memory card with the contacts upwards and
pointing towards the multi scanner into the memory card slot [6] until it snaps into place.
Remove the memory card from the deactivated
multi scanner. To remove the memory card,
press it lightly. The memory card is ejected
slightly and can be pulled out.
Write protection activated
SilverCrest SMS 5.0 A1
English - 101