Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operating Instructions
pre-Operation
LUbrICaTIOn
Air tools require lubrication through-
out the life of the tool. Proper
lubrication is the owner's responsibility.
Use Campbell Hausfeld airtool oil (Part
No. ST127000AV) to lubricate, clean
and inhibit rust in one step. Failure to
lubricate and maintain air tool properly
will dramatically shorten the life of the
tool and will void the warranty.
This air tool
requires lubrication
before initial use and before and after
each additional use.
1. Disconnect tool from air supply.
2. Turn cutting tool upside down.
3. While pressing throttle control lever,
pour a teaspoon of Campbell
Hausfeld oil in the air inlet.
Cover exhaust port
with a towel before
applying air pressure. Oil will discharge
through exhaust port during first few
seconds of operation after an airtool
has been lubricated. Failure to cover
exhaust port can result in serious
injury.
4. Release throttle lever and connect
air tool to air supply. Cover exhaust
port with a towel then run air tool
for 20 to 30 seconds. Oil will
discharge from exhaust port when
air pressure is applied. Continue to
run cutting tool until no oil is
discharged. Wipe all residual oil off
of tool before use.
www.chpower.com
Operation
aTTaChmenTS
Disconnect air tool
from air supply
before changing attachments or serious
injury could occur.
Make sure cut-off
wheel is tightened
securely before operating air tool.
ChanGInG CUT-Off WheeLS
1. Remove the cap screw holding the
cut-off wheel. Remove the cut-off
wheel (See Figure 1). Arbor wrench
is included with some models.
Arbor
Wrench
figure 1
2. Check condition of new cut-off
wheel. Never use wheels that are
cracked, chipped or damaged in any
way.
3. Center new cut-off wheel on arbor
(See Figure 2). Make sure cut-off
wheel is rated for RPM of air tool.
Securely tighten cap screw.
Cutting
Wheel
Arbor
figure 2
2
to the tool. Only use 3" max. diameter
cut-off wheels rated at or above tool
rated RPM.
Storage
Lubricate air tool before storing. Follow
lubrication instructions in Pre-Operation
section with an exception to step 4. Run
cutting tool for only 2 to 3 seconds so
more oil will remain in air tool for
storage.
Technical Service
For information regarding the
operation or repair of this product,
Cap Screw
please call 1-800-543-6400.
replacement parts
Information
For information regarding where to
order replacement parts, call toll free
1-800-543-6400. Please provide the
following information:
• Model number
• Stamped-in code
Allen
• Part number and description
Wrench
Address parts correspondence to:
The Campbell Group
Attn: Parts Department
100 Production Drive
Harrison, Ohio 45030 U.S.A.
Safety
Guard
Cut-off wheels must
be securely fastened
Tabla de contenido
