Klarstein Pure Blizzard Smart 7k Manual Del Usuario página 36

EN
36
Installation of the heat exhaust hose assembly and unit
• Pull the end of the heat exhaust hose apart by several turns.
• Hold the end handle of the C shape buckle with the left hand and the heat exhaust
hose short connector with the right hand, put one end of the heat exhaust hose that
is pulled apart onto the snap of the lower air duct bottom, press the C shape buckle
with the left hand by force so that the C shape buckle of the heat exhaust hose clips
the snap joint of the back shell. The end of the heat exhaust hose must reach one
step inside the bottom of the lower air duct (see picture).
• The few turns at the end of the heat exhaust hose must be snapped in the snap of
the lower air duct bottom. The C shape buckle that clips the heat exhaust hose must
clip the back shell and heat exhaust hose firmly. Hold the unit with one hand and
the heat exhaust hose short connector with another hand; or both people cooperate
with one person holding the unit and the other person pulling the heat exhaust hose
to prolong the heat exhaust hose gently.
Installation of the window sealing board assembly
Half open the window and mount the window sealing board assembly onto the window,
either vertically or horizontally (see picture). Pull apart the parts of the assembly, adjust
the distance of assembly pulled apart so that the two ends of the assembly come into
contact with the frame, and fasten the parts of the assembly with screws.