Transport And Storage; Accessories - Honda UMK425E Manual Del Propietário

TRANSPORT AND
STORAGE
TRANSPORT
When transporting or carrying your brushcutter, the engine
must always be stopped and the transport guard must be
installed on the cutting attachment.
When carrying your
brushcutter, hold it by the
transmission tube in a
balanced position. If it is to be
transported in a vehicle, make
sure that it is properly secured
so it cannot move. It must be
positioned so that there is no
risk of fuel leakage.
STORAGE
If the machine is not to be used for more than two months, the
following storage precautions should be taken:
- Drain the fuel tank and run the engine to empty the carburettor.
- Remove the spark plug and pour a few drops of oil (same quality
as that used in the engine) into the cylinder.
- Gently pull the recoil starter to distribute the oil in the cylinder and on
the piston. Then reinstall the spark plug.
- Clean the whole machine, paying special attention to plant
residues accumulated around the cutting attachment, in the
engine cooling fins and under the cowlings.
- Using a paint brush, apply a thin film of standard oil over the metal
cutting attachments to prevent corrosion.
- Store the machine in its packaging, in a cool dry place.
- If the machine is to be stored in a vertical position, place it with the
engine at the bottom so that it will not topple over.
FOLDING THE HANDLE (UEET TYPE ONLY)
For easier storage, the handle on your brushcutter can be swivelled
round. Proceed as described below.
CAUTION:
• Turn the handle the clockwise only.
• Never swivel the handle through more than a quarter of a turn.
• Do not unscrew the knob [1] by more than 6 turns.
2
1
[1]
D1 D4
D8 D10
SAFETY
USING THE AFTER A STORAGE PERIOD
1. Remove the spark plug, check that it is clean and that the electrode
gap is correct. Pull the starter several times.
2. We recommend that the spark plug be screwed down as far as
possible by hand until finger tight; then use a plug spanner to
tighten it by an extra 1/8 or 1/4 turn.
3. Check the level and condition of the engine oil.
4. Fill the fuel tank and start the engine.
NOTE : If the cylinder has been coated with oil, the engine will smoke
on start-up. This is normal.

ACCESSORIES

CURRENT PARTS, CONSUMABLES
Various accessories are supplied with the machine or are available as
options, depending on the model.
Mowing and clearing
Thorny hedges and brush
Large areas of grass
Knotty brush and bushes (optional for model UMK435E UEET)
Current parts
3
Consumables
For your safety, it is strictly prohibited to
install any other attachment than the ones
listed above and especially designed for
your brushcutter's model and type.
UMK425E UMK435E
LEET UEET LEET
72560-VL6-P31
Standard
72511-VL6-P31 (Ø 255 mm)
Standard
72511-VF9-E32 (Ø 230 mm)
72512-VL6-P31 (Ø 255 mm)
Optional
-
Prohibited
17211-Z0H-000 17211-Z0Z-000
Air filter
31915-Z0H-003
Spark plug
28462-ZM3-003
Recoil starter
08221-888-010MP
Engine oil
UEET
72511-VL6-H31
(Ø 200 mm)
Optional
A2 C4
C14 D3
SAFETY
13 EN