Installation Instructions; Before Installation - Hotpoint RAG70 Instrucciones De Instalación

Introduction
packages terminal air conditioner and heat pump.

Before Installation

removed to provide clear access through the wall
sleeve for proper grille installation.
IMPORTANT:
could result in condenser (outdoor) air recirculation.
shorten product life.
1. Check Proper Grille Orientation
Before attempting to install grille, be sure to check it
with drain tube slots downward.
2. Check Mounting Screws
preset on the grille.
IMPORTANT: When installing grille, be sure to
Wall Sleeve with Rear Closure Panel:
REAR CLOSURE
PANEL
SLEEVE
SLEEVE CENTER
SUPPORT
2

Installation Instructions

FLANGE
3. Aligning the Grille
1. Using the ribbon handle on the grille, place the
the room side.
hand, tighten the (4) screws.
Screws
Room side Wall
4. Securing the Grille
For added support, insert 2 additional included screws
in center top and bottom of grille.
the wall sleeve.
Mounting Baffles Mounting
Screws Screws
5. Remove the ribbon handle
from the Grille
NOTE: If the chassis has air deflectors installed on the
to prevent condensor (outdoor) air recirculation.
Ribbon Handle
Back Side Mounting
Wall Sleeve Screws