Cleaning - Solera Eco Manual De Empleo Y De Mantenimiento

We do not recommend to
connect the machine through
adaptors, multiple plugs and/or
extensions. If necessary, use
only materials that conform to
the safety rules in force, as for
the current intensity up to what
indicated on the plate (pic. 4
pag. 17).
Place the machine so as to
avoid any heat source to be
close to the grids. Verify that
there is a free space of 25 cm
at least around the machine
(pic. 5 in appendix-91).
After connecting the machine to
the power supply and switching
on the main switch, verify that
air comes out from the side
grids (pic. 6 in appendix-91).
Lid stickers
All refrigerators are equipped
with 2 stickers for each single
lid. The stickers must be
applied as showed in the
pictures:
Right usage
Before switching on the
machine, it is necessary to
clean it as indicated in the
"Cleaning" paragraph.

Cleaning

Cleaning is very important for
the life and maintenance of the
machine; we recommend to
periodically clean the parts that
are in contact with the product
using the following procedure.
Warning!
Switch off the main switch
and disconnect the power
plug (pic. 7 in appendix-91)
before starting any operation.
Use a solution of cold water
and sodium hypochlorite
(bleach) with a 10 grams (1/2
spoon) for 1 liter of water ratio.
Rinse with lukewarm water.
Warning! A greater quantity
of beach could damage the
material of the auger.
Warning! If the plastic parts
are washed in the
dishwashing machine, verify
that the temperature is not
higher than 85°C or 185°F,
because they could be
damaged.
Do not use any abrasive
powder.
Tank cleaning procedure
See the picture at the end of
this manual.
 Empty the tanks by opening
the outlets and blocking
them (pic. 8 in appendix-
91), moving the little letter
from the left to the right.
- 19 -
 Remove the lamp (pic. 9 in
appendix-91), pour water in
the tanks and then empty
them.
 Remove the auger ring nut
(pic. 10 and 11 in appendix-
91).
 Remove the tank
unscrewing the hooks grips
(pic. 12 in appendix-91), if
present, and opening the
hooks (pic. 13 in appendix-
91); lift the tank as shown in
pic. 14 and 15 in appendix-
91.
 Unscrew the ring nut (pic.
16 in appendix-91) in order
to remove the vertical auger
(pic. 17 in appendix-91).
 Remove the horizontal
auger; this way the inox
side of the tank is
completely open and ready
to be cleaned (pic. 18 and
19 in appendix-91).
 Remove the outlet (pic. 20,
21, 22, 23 in appendix-91)
and the tank gasket (pic. 24
in appendix-91):
 Remove the lever cover
(pic. 20 in appendix-91)
by pushing "PUSH"
downward; and remove
the lever (pic. 21 in
appendix-91);
 Rotate the ring nut
clockwise (pic. 22 e 23
in appendix-91) and pull
the outlet.
 Dip the dismantled parts in
the solution of water and
bleach.
 Wash and dry.
 Wet the gasket before
inserting it in place (pic. 24
in appendix-91), be careful
to place the gasket joint in
one of the back corners of
the tank in the proper
allocation.
 Reassemble everything.