Safety Instructions; Positioning Ip Cameras; Installation Instructions - PNI House WiFi550 NVR Manual De Usuario

EN

SAFETY INSTRUCTIONS

• Do not install the product in a damp or dusty environment
• Install the NVR in a well-ventilated environment
• Check the power source before installing the NVR to avoid problems caused by inappropriate power
supply
• Install the NVR on a flat, horizontal, vibration-free surface
• If dust enters the main board, it may cause a shortcircuit if it gets wet. Wipe the main board dust,
connectors, and NVR casing
• If the battery is discharged, use the same type of battery. Do not open or attempt to repair the battery.
• Use only recommended hard drives for surveillance systems to ensure continuous and stable recording
NVR INSTALLATION SCHEME

POSITIONING IP CAMERAS

The shape of the wireless signal coverage area is round, with the antenna positioned in the center. The signal
is stronger around the antenna. Based on how the wireless waves spread, position the IP cameras parallel or
perpendicular to the NVR to provide a stable signal and quality images.

INSTALLATION INSTRUCTIONS

1. Make holes in the wall at least 30 mm deep
2. Fix the camera to the wall. Use 3 PA4 screws
3. Unscrew the screw on the bracket to turn the camera as needed
4. Install the Hard Disk into the NVR. Be sure to disconnect the power before installation
NVR REAR PANEL DESCRIPTION
Antenna
Right
AUDIO VGA
output output
2
Wrong
HDMI Ethernet USB2.0 Power supply
output 12V DC