Mellerware SWISS Manual Del Usuario página 2

Dear customer,
Thank you for choosing to purchase a Mellerware
brand product. Thanks to its technology, design and
operation and the fact that it exceeds the strictest qual-
ity standards, a fully satisfactory use and long product
life can be assured.
1
2
3
4
1. Parts description
1. Handle
2. Pilot lamp
3. Thermostat
4. On/Off selector switch
2. Safety advice and warnings!
Read these instructions carefully before switching
on the appliance and keep them for future reference.
Failure to follow and observe these instructions could
lead to an accident. Clean all the parts of the product
as indicated in the cleaning section, before use.
2.1. Use or working environment:
2.1.1. Keep the working area clean and well lit. Clut-
tered and dark areas invite accidents.
2.1.2. Use the appliance in a well ventilated area.
2.1.3. Do not place the appliance on hot surfaces, such
as cooking plates, gas burners, ovens or similar items.
2.1.4. Keep children and bystanders away when using
this appliance.
2.1.5. Place the appliance on a horizontal, flat, stable
surface and away from other heat sources and contact
with water.
2.1.6. Keep the appliance away from flammable mate-
rial such as textiles, curtains, cardboard or paper, etc.
2.1.7. Do not place flammable material near the appli-
ance.
2.1.8. Do not use the appliance in association with a
programmer, timer or other device that automatically
switches it on.
2.1.9. Do not use the appliance if the cable or plug is
damaged.
2.1.10. Ensure that the voltage indicated on the rating
label matches the mains power supply voltage before
plugging in the appliance.
2.2.11. Connect the appliance to the mains power
supply with an earth socket withstanding a minimum of
16 amperes.
2.1.12. The appliance's plug must fit into the mains
power supply socket properly. Do not alter the plug.
2.1.13. If using a multi plug check ratings carefully as
the current used by several appliances could easily
exceed the rating of the multi plug.
2.1.14. If any of the appliance casings breaks, imme-
diately disconnect the appliance from the mains power
supply to prevent the possibility of an electric shock.
2.1.15. Do not use the appliance if it has fallen on the
floor or if there are visible signs of damage.
2.1.16. Do not force the power cord. Never use the
power cord to lift up, carry or unplug the appliance.
2.1.17. Do not wrap the power cord around the appli-
ance.
2.1.18. Do not clip or crease the power cord.
2.1.19. Do not allow the power cord to hang or to
come into contact with the hot surfaces of the appli-
ance.
2.1.20. Check the state of the power cord. Damaged or
tangled cables increase the risk of electric shock.
2.1.21. The appliance is not suitable for outdoor use.
2.1.22. Power cord should be regularly examined for
signs of damage, and if the cord is damaged, the appli-
ance must not be used.
2.1.23. Do not touch the plug with wet hands.
2.1.24. Allow a 50cm safe area around the top and
sides of the heater with a 120cm safe area in front.
2.1.25. Never use a heater in a room with explosive
gas such as petrol or while using any kind of flam-
mable glues, sprays or solvents.
2.1.26. Prevent overheating of the appliance by keeping
the air inlets and outlets clean and free of anything that
may cause blockage. Check all inlets and outlets from
time to time for accumulated dust. DO NOT COVER.
2.1.27. If overheating should occur, the built-in over-
heating safety device will switch the appliance off.
2.1.28. Do not insert any foreign objects into the grill.
2.1.29. Keep the rear grill clear of any draped fabric or
curtains.