Multifunction Button - KlipXtreme TwinBuds II Manual Del Usuario

1 Magnetic charging socket: Place each
earphone in the corresponding left and right
side to recharge.
2 On/Off button: Press this button once to
turn the case on to charge the earphones.
Press and hold this button for about two
seconds to turn it o .
3 Charging case LED indicator: The LEDs
will blink consecutively in white indicating that
the device is being charged. Once the fourth
LED indicator is solid white, they will stop
blinking and stay solid to indicate that it is fully
charged.
4 Charging port: Insert the micro-USB cable
in this jack.
5 Silicone ear fins: Adjust them correctly into
your outer ear for a secure fit.
6 Built-in microphone: Picks up your voice to
enable hands-free calling and conferencing.
Earphones LED indicator: The LED turns
solid red when the case is turned on and
charging the earphones. Once the earphones
are fully charged the red light will turn blue,
after about 1 minute the light will turn o and
it will stop charging.
7 Power/Multifunction button: Press the
multifunction button to power the earphones
on and o . Press this button also to start and
pause media, and to answer or end an
incoming call.
8 Earphone magnetic contacts: Place the
left and right earphones properly in the
charging case to start receiving charge.
9 Sets of silicone tips (medium and large
size): Interchangeable silicone tips to adjust
to your needs and provide a comfortable fit
for hours.
Earphone multifunction button with LED
status indicators:

Multifunction button

Mode
Press and hold to go into pairing mode (if the
Pairing
earphones are not automatically in pairing mode)
Briefly press to answer and end an incoming call
Hands-free
Press it three times to redial the last number called
mode
Press and hold for about 1 second to reject or
ignore an incoming call
Briefly press the right or left button to play and
Playback
pause audio
mode
Press the button on the left earphone twice to
move backward in your playlist
Press the button on the right earphone twice to
move forward in your playlist
Voice Assistant for Siri and Google commands
Note: To enable this function a compatible mobile phone is required.
•When audio is being played or paused, press the Power/Multifunction
button for about 2 seconds to enable the Voice Assistant for Siri or
Google. Press this button again to turn it off.
Function