Making The Electrical Connection; Attaching The Fan Blades - HAMPTON BAY 52869 Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
9

Making the electrical connection

WARNING: Each wire not supplied with this fan is designed to
accept up to one 12-gauge house wire and two wires from the
fan. If you have larger than 12-gauge house wiring or more
than one house wire to connect to the fan wiring, consult an
electrician for the proper size wire nuts to use.
IMPORTANT: Use the wire connecting nuts (DD) supplied with
your fan. Secure the connectors with electrical tape and ensure
there are no loose strands or connections.
□
Connect the ground conductor of the 120-Volt supply (this
may be a bare wire or a wire with green colored insulation) to
the green ground lead(s) (UU) of the fan.
□
Connect the fan motor white wire (VV) to the supply white wire
(VV) using a wire connecting nut (DD).
□
Connect the fan motor black wire (WW) to the supply black
wire (WW) using a wire connecting nut (DD).
□
After connecting the wires, spread them apart so that the
green (UU) and white wires (VV) are one side of the outlet box
(XX) and the black wire (WW) is on the other side.
□
Turn the wire connecting nuts upward, and carefully push the
wiring into the outlet box (XX).
Assembly (continued)
10

Attaching the fan blades

NOTE: The blade and blade arms are pre-assembled
together at the factory. The blades feature new technology
for higher efficiency. The blades are not reversible.
□
Position the blade assembly (E) on the motor so the
mounting screw holes align with the threaded holes.
□
Turn the screw (JJ), spring washer (KK), and flat washer (LL)
into the hole but do not completely tighten. Make sure the
second hole in the blade assembly aligns with a hole in the
motor housing (G).
□
Install a second screw (JJ), spring washer (KK) and flat
washer (LL) in the blade assembly in the same manner.
□
Repeat for the remaining blades.
□
Tighten all screws.
WW
WW
JJ
KK
E
LL
10
XX
G