Description And Use; Compliance - Vortice VORT HRW 30 MONO EVO Manual De Instrucciones

ENGLISH

Description and use

VORT HRW MONO EVO (hereinafter "device") is a decentralized heat recovery ventilation system, which can be
installed on perimeter walls with thickness between 260 mm (283 for VORT HRW 40 MONO EVO) and 700 mm.
The device is available in four versions:
- Installation inside holes with a nominal diameter of 100 mm and a maximum air flow rate (in boost mode) of
3
38 m /h:
• VORT HRW 30 MONO EVO with on-board machine controls.
• VORT HRW 30 MONO EVO HCS with remote control and relative humidity, temperature and ambient
light sensors.
- Installation inside holes with a nominal diameter of 160 mm and a maximum air flow rate (in boost mode) of
3
40 m /h:
• VORT HRW 40 MONO EVO with on-board machine controls.
• VORT HRW 40 MONO EVO HCS with remote control and relative humidity, temperature and ambient
light sensors.
Humidity, temperature and ambient light sensors. integrated in HCS versions, allow the automatic operation of
the device ("Auto HR%", "Auto Comfort", "Auto night" functions).
- Maximum absorbed power VORT HRW 30 MONO EVO: 4W.
- Maximum absorbed power VORT HRW 40 MONO EVO: 5W.
Common features for all models:
- 5 speeds corresponding to 5 airflows.
- 1 input suitable for remote connection with cable compatible with external modules "VORTICE C TEMP"
(temperature sensor) and "VORTICE C HCS" (humidity sensor) or equivalent. Cable length≤30m.
- 1 direct output for fan control.
- RS485 communication BUS to synchronize together pairs of devices.
- Long-term timer (3/6/12 months) with daily increase for filter clogging control.
- Insulation class: II.
- Power supply: 220-240V ~ 50-60Hz.

Compliance

• This appliance can be used by children no less than 8 years of age
and by individuals with limited physical, sensory or mental capacities,
or by inexperienced or untrained individuals, provided that they are
supervised or have been instructed in safe use of the appliance and
understand the associated risks. Children must not play with the
appliance. Cleaning and maintenance procedures that can be
undertaken by the user must not be entrusted to children, unless
under supervision.
• These appliances are designed for use in residential and commercial
properties.
• The appliance must be installed by a professionally qualified
electrician.
• The electrical system to which the product is connected must be in
compliance with applicable regulations.
• An omnipolar switch with a contact opening distance of 3 mm or
higher should be provided for installation, enabling complete
disconnection under overvoltage category III conditions.
• Products equipped with single-phase wiring (M) engines ALWA YS
require connection to 220-240V (or only 230V where required) single-
phase lines. Any kind of modification shall be considered as product
tampering and shall nullify the relative warranty.
26