Work Pro W Light Mouse Serie Guía Rápida página 3

4. Connect a Cat 5 cable in order to link the device in a LAN
5. This connector is used to supply the device. Connect an external DC 5V - 350 mA power supply taking
into account the corret polarity as marked in the drawing, with the GND pin as the more external
terminal.
Installing WORKCAD software
Considering that AR 5N uses the
WorkCAD is available from
AR 5N (Connection)
AR 5N must be connected to an ethernet LAN using a Cat 5 cable with RJ 45. In this case is advisable that the
network has DHCP, which will provide a valid IP address to the device.
In the same network must be connected a computer with WORKCAD control software installed and the LM5
which has the show data that we want to control.
NOTE: If your network has no DHCP connection, the device will assign to AR 5N an IP within 169.254.XX
range, being XX a direction supplied by the device upon its connection to not interfere with other devices in the
same network. WORKCAD software will detect the device for configuration.
WORKCAD (Main Screen)
WORKCAD software supports multiple WORK compatible devices. The generic interface is common to all were
differences by controls and parameters capabilities and configuration of each individual device type. The main screen shows the large blocks into the program.
PROJECT
INSPECTOR
DEVICES
Quick Guide
WorkCAD software , the installation process must be completed previously,
Equipson WebSite .
- 2 -
EN
AR 5N
INTERFACE
www.work.es