Baby Jogger city GO i-Size Manual De Instalación página 14

EN
CAR SEAT INSTALLATION AND UNINSTALLATION
1 Rotate Support Leg Out
2 Place base on vehicle seat. The support leg has two
buttons to allow the length to be adjusted. Press the
buttons to adjust the leg length. The support leg must
contact the vehicle floor. Make sure the load leg is
secure by pressing down on the base.
3 Extend the ISOFIX connectors.
Squeeze the ISOFIX extend buttons and pull the
ISOFIX connectors out.
4 Press the ISOFIX connectors onto the vehicle anchors
until a click is heard. When the ISOFIX connectors are
locked the connection indicators will be green. If the
base is not locked in the indicators will be red.
5 Squeeze the ISOFIX extend buttons. Push down firmly
on the base towards the back of the vehicle seat to
ensure a tight on the seat.
6 To release the base from the vehicle seat pull the
ISOFIX release lever and remove base.
RECLINE CAR SEAT
7 To recline the car seat pull recline handle and slide into
correct position for your child.
ATTACHING THE CAR SEAT TO THE BASE
8 To attach seat to base, position front of seat in base
then push down on the back until it locks into place.
Pull up on car seat to be sure it is securely fixed onto
base.
9 To remove, squeeze release handle at back of the
car seat to release the attachment catch. Lift car seat
from base as shown. Always place handle in the down
position when removing your baby from the seat and if
you place the car seat onto the floor.
14