Maintenance And After-Sales Service; Warranty Conditions - ICA PLUS PLANT LIGHT AquaScape Manual De Usuario

photoperiod was selected.
- Example 1: Photoperiod selected at 8.00 a.m. for 10h. The light will remain on from
8.00 a.m. to 6.00 p.m., and will switch back on the next day at 8.00 a.m.
- Example 2: Lamp switches on at 8.00 a.m., but the photoperiod is selected at 9.00
a.m. for 10h. The light will remain on at that time for the 10h, and will switch off at
7.00 p.m. and switch back on at 9.00 a.m. the next day, when the photoperiod was
initially selected.
3. The required lighting mode can be selected using the Mode change button
4. To change the direct modes preconfigured, each of the colours of the lamp can be
adjusted independently using the red (R), green (G) or blue (B) light intensity button.
5. The controller can also adjust the total brightness of the lamp. In all modes, this
brightness can be adjusted using the Brightness +
6. Sunrise/Sunset mode (Dimmer): Press the Enable Sunrise/Sunset mode button
imitate the progressive increase and decrease of light during sunrise and sunset. This
can only be enabled if a photoperiod is selected.
This mode increases the light intensity over a 3h period at the rate of 30% intensity
during the first hour, 60% intensity during the second hour, and 100% intensity as of
the third hour, and decreases it in the same way, respecting the total hours of light
selected in the photoperiod.
Sunrise/Sunset mode will start operating as soon as the lamp switches on, so it is wise
to first enable Sunrise/Sunset mode and immediately afterwards select the required
photoperiod.
- Example 1: If you enable Sunrise/Sunset mode at 8.00 a.m. with a photoperiod of
10h, the intensity will be 30% at 8.00 a.m., 60% at 9.00 a.m., 100% from 10.00 a.m.
to 3.00 p.m., 60% at 4.00 p.m., 30% at 5.00 p.m., and 0% at 6.00 p.m., to give a
total of 10h of light.
- Note: If you set the 10h photoperiod at 8.00 a.m. and forget to enable Sunrise/Sunset
mode, you can enable it later. In this case, if you enable it at 12.00 p.m., for example,
the light will remain at 100% until 4.00 p.m. before dimming to 30% at 5.00 p.m. and
0% at 6.00 p.m. The next day, the same series will be repeated from 8.00 a.m., this
time with gradual switching on and off, as explained in Example 1.

MAINTENANCE AND AFTER-SALES SERVICE

If the product is in need of repair, contact the distributor for the after-sales service.
Furthermore, to avoid damage during transport, make sure it is packaged carefully. If the
damage to the product is not due to quality problems, contact the sales representative or
authorised store in order to purchase the relevant accessories or pay a maintenance fee.
Faults caused by improper installation, misuse and other reasons are not covered by the
warranty.
Manipulating, dismantling or transforming the product is strictly forbidden. Our company will
accept no product repair or customer complaint in the event of any manipulation, repair or
transformation.

WARRANTY CONDITIONS

1. Two-year warranty. If the fault is not due to misuse but is related to the material and
design of the product, replacement or maintenance will be free of charge for these two
years (to replace the product, its appearance must not be damaged so that it can be sold).
Following the two-year period, any replacement expenses will be charged.
2. If the product does not work because of a serious problem, it can be returned to the factor
(N.B. you must make sure its appearance is not damaged and pay for all delivery costs).
The refund will be made after the product has been received.
3. Technical support for the products sold.
4. Free maintenance does not include damages not attributable to our company due to:
Incorrect installation. Voltage incompatibility. Incorrect use by not following the
operation instructions. Maintenance or modification not authorised by the company.
Lack of the necessary maintenance. Inadequate operating environment. Damage
caused by the user´s secondary transport. Fault not attributable to our products. Force
majeure due to natural disasters (lightning, earthquakes, tsunamis, etc.) and accidents.
ENGLISH
and Brightness - buttons.
to