Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How to Stop Your Pressure
Washer
1.
Let engine idle for two minutes.
2.
Move throttle lever on engine to "Stop" position.
3.
ALWAYS point gun in a safe direction and
squeeze spray gun trigger to release retained high
water pressure.
IMPORTANT: Spray gun traps high water pressure,
even when engine is stopped and water is disconnected.
I
A WARNING
1
• Keep
high pressure
hose connected
to pump
and spray
gun while
system
is pressurized.
• ALWAYS
point
gun in safe direction
and squeeze
spray
gun trigger,
to release
high pressure,
every time
you stop
engine.
Engage
trigger
lock when not in use.
4.
Engage trigger lock on spray gun when not in use.
How to Use Spray Tips
The quick-connect
on the nozzle extension allows you
to switch between four different spray tips. The spray
tips vary the spray pattern as shown below.
Low Pressure
Black
Use to apply
detergent
High Pressure
40 ° White
15° Yellow
0 ° Red
Follow these instructions to change spray tips:
1.
Engage trigger lock on spray gun.
_
NEVER
exchange
spray
tips without
engaging
the trigger_
lock on the spray
gun.
J
2.
Pull back collar on quick-connect
and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
,
Select desired spray tip:
•
For gentle rinse, select white 40 ° spray tip.
•
To scour surface, select yellow 15 ° or red 0 °
spray tip.
•
To apply detergent, select black spray tip.
Usage Tips
•
Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
•
For most effective cleaning, keep spray tip from
8 to 24 inches away from cleaning surface. If you
get spray tip too close, you may damage cleaning
surface.
*
DO NOT get closer than 6 inches when cleaning
tires.
Cleaning
and Applying
Detergent
IMPORTANT:
Use detergents
designed
specifically
for pressure
washers.
Household detergents could
damage the pump.
CAUTION
,
2.
,
Starting
the engine
without
all the hoses
connected
and
without
the water
turned
ON will damage
the pump.
Damage
to equipment
resulting
from failure
to follow
this
instruction
will void warranty.
Review spray tip use.
Prepare detergent solution as required by
manufacturer.
Place filter end of detergent siphoning tube into
detergent container.
CAUTION
When
inserting
the filter into a detergent
solution
bottle,
route the tube
so as to keep it from inadvertently
contacting
the hot muffler.
10
Tabla de contenido
