THERMEx TX II Motor Instrucciones De Montaje página 39

M 225191200215032021
7
The motor is mounted in the motor box, inside
the condenser box, fastened with screws. The
side of the motor box is then reassembled.
10
Mount the spacer on the flange with the valve.
This is done to ensure that the valve can open
freely when the exhaust is mounted.
8
x8
Put the lid on the condenser box and pull the
power cable for the motor out through the
small hole in the lid.
11
Position the engine as desired. Install exhaust
from the hood to the engine, and from the en-
gine to the outdoors.
NOTE: If necessary, place the motor on vibra-
tion-damping surfaces.
THERMEX TX II MOTOR
9
Fit the supplied strips around the condensate
box.
12
Pipes and hoses must be insulated in unheated
rooms so that no condensation forms.
WARNING !: Damage to the device caused by
condensation is not covered by the right of
complaint.
39