Amplifier Wiring; Power Connections; Speaker Connections Xtr2502 And Xtr5002 - Orion XTR2502 Manual Del Propietário

AMPLIFIeR WIRInG

Power Connections

• Power connections accept up to 4 AWG wire .
• 4 AWG power and ground wire recommended for optimal per-
formance .
• Connect 12V+ to the battery through fuse holder . this connec-
tion provides +12V main power to the amplifier .
• Power wire must be fused no more than 12" from battery .
• Ground amplifier to a good chassis ground as close as possible to
the amplifier .
• Recommended fuses are 50A for the XtR2502, and 100A for the
XtR5002 .
• Connect ReM terminal to remote turn-on lead from source unit .
this connection provides +12V power to turn-on the amplifier .
• Add extra ground wire between the negative terminal of the
battery and the chassis .
NOTE: the addition of a ground wire from the battery to the chassis
of the vehicle improves the ability of the battery to supply power to
the amplifier . this is recommended because the current delivery of the
factory electrical system was designed only to accommodate electron-
ics supplied by the auto manufacturer .
© 2008 Directed Electronics. All rights reserved.

Speaker Connections XTR2502 and XTR5002

the orion XtR2502 and XtR5002 amplifiers offer one positive and one
negative output terminal for ease of connecting channel 1 and/or 2
outputs to the speakers . the amplifiers are stable to 2Ω per channel .
see diagrams below .
one Channel/two Channel Configuration
• Lowest recommended impedance is 2
• outputs can be configured for high-pass, low-pass, or full range
operation .
+
L CH
Figure 10
Figura 10
Abbildung 10
+
L CH
Ω stereo .
_ _
+
R CH
_ _
+
R CH
9