BLACK&DECKER PW1300 Manual De Instrucciones página 6

598111-01,PW1300 manual
YOUR PRESSURE WASHER IS NOW
READY TO USE - PLEASE REVIEW
THE FOLLOWING FOR DETAILS ON
ACCESSORIES APPLICATION.
ACCESSORIES
CAUTION: Before changing
accessories, turn unit off, pull trigger
to release pressure, and activate
safety catch.
• ADJUSTABLE FAN WAND
1.) Insert the fan wand (D) into the gun
wand (E) by pushing and rotating until
the two parts are locked as shown in
Figure A.
A
2.) To obtain maximum pressure, rotate
the fan wand nozzle in a clockwise
direction as shown in FIgure B. This
narrow stream results in deeper cleaning
in a concentrated area. For a wider fan
pattern rotate the fan wand nozzle in the
counterclockwise direction. The wider
fan pattern reduces the risk of surface
damage and allows for cleaning large
surface areas quickly.
B
3.) To remove, press wand into gun and
twist as shown in Figure C.
C
• TURBO NOZZLE
1.) Insert the turbo nozzle (C) into the
gun wand (E) by pushing and rotating
until the two parts are locked as shown in
Figure D.
1/31/05 1:51 PM Page 6
D
2.) There is no adjustment required with
the turbo nozzle.
3.) To remove, press nozzle into gun and
twist as shown in Figure E.
E
• DETERGENT APPLICATOR
Follow manufacturer's label directions for
mixing correct concentrations of soap
and detergents.
To use the applicator:
1.) Unscrew top of detergent applicator
(G) and fill with detergent.
2.) Replace top.
3.) Insert detergent applicator (G) into
gun wand (E). Twist detergent bottle until
it clicks firmly into place as shown in
Figure F.
F
4.) Apply detergent from the bottom to
the top to prevent detergent from sliding
down and streaking.
5.) Leave detergent on the surface for a
few minutes but do not allow it to begin
to dry.
6.) Remove detergent applicator from the
gun wand by turning the detergent bottle
1/4 turn and pulling straight out.
7.) Rinse detergent from surface.
8.) Flush detergent applicator with clean
water.
6