Commercial Electric 17898 Guía De Uso Y Cuidado página 6

Installation (continued)
3
Preparing the assembly location
□
Power the LED tape lighting and temporarily hold or tape into position with painter's tape or masking tape - do not remove
the 3M paper backing.
Adjust the lighting to various angles and positions to get the desired level of illumination and lighting appearance. If the
□
try a different mounting angle.
□
4
Installing the LED strip
□ 4A Tape method: Working from one end to the other, remove the 3M paper backing and press into place. Press between the LEDs to
help ensure secure contact with the mounting surface. Avoid pressing on the individual LEDs as this could damage the LED solder
connections.
4B Clip and screw method: Place the LED strip in the desired position. Use the clips and screws to secure the LED strip as shown.
□
Clips should be placed in open areas of the strip. Do not cover the LED lights.
Plug the adaptor into the wall receptacle and then use the remote to turn the LED's on.
□
4A
Note :
a.
Angle 90
a. Use an angle greater or equal to 90 degrees when there is an LED chip on the corner
while placing the strip in a concave position. (Angle 90 )
b. Use an angle greater or equal to 60 degrees when there is no LED chip on the corner
while placing the strip in a concave position. (Angle 60 )
c. Use an angle greater or equal to 60 degrees when there is an LED chip on the corner
while placing the strip in a convex position. (Angle 60 ) In the convex position the
angle should not reach 90 degrees. See above diagram.
b.
LED Chip
o
o
Angle 60
IMPORTANT: Before removing the 3M paper backing, it is
important to test the LED strip in the space you intend to light.
Once the 3M paper backing is removed and the lighting is fully
installed, you cannot reposition or move the LED tape light to
another location. The tape may not stick securely.
4B
c.
Correct lncorrect lncorrect
6
erly.